| Step | | Procedure & Parts & Tools |
| 1 |
|
PUSH IN ON THE 2 ORANGE TABS TO REMOVE THE BASE COVER.
|
| 2 |
|
REMOVE THE BASE COVER.
|
| 3 |
|
LOOSEN THE BRUSH HEIGHT KNOB AND REMOVE IT. SET IT ASIDE.
|
| 4 |
|
FLIP THE BASE OVER AND REMOVE THE 5 SCREWS.
| Screwdriver-phillips |
|
|
| 5 |
|
FLIP THE BASE BACK OVER AND REMOVE THE BRUSH MOTOR COVER.
|
| 6 |
|
LOCATE THE 2 WHITE RING BRACKETS HOLDING THE UPPER BODY TO THE BASE. PULL OUT ON THE 2 WHITE RING BRACKETS. LAY THE UPPER BODY FLAT. PULL THE UPPER BODY AWAY FROM THE BASE TO SEPARATE IT FROM THE BASE. NOTE: BE CAREFUL NOT TO DAMAGE THE MICROSWITCH ON THE RIGHT SIDE OF UNIT.
|
| 7 |
|
REMOVE THE 6 SCREWS HOLDING THE VAC COVER TO THE UPPER BODY.
| Screwdriver-phillips |
|
|
| 8 |
|
PULL THE VAC COVER TO SEPARATE IT FROM THE UPPER BODY.
|
| 9 |
|
PULL THE POWER SUPPLY PLUG APART TO DISCONNECT IT.
|
| 10 |
|
LOCATE THE 2 BLUE WIRES AND THE YELLOW/GREEN WIRES FROM THE VAC MOTOR TO THE TERMINAL BLOCK. LOOSEN THE SCREWS IN THE TERMINAL BLOCK FOR THESE WIRES. PULL THE 3 WIRES FROM THE TERMINAL BLOCK.
| Screwdriver-flat tip |
|
|
| 11 |
|
PULL THE VAC MOTOR FROM THE VAC MOTOR COVER.
|
| 12 |
|
THE VAC MOTOR IS NOW FREE FROM MACHINE.
|
| 13 |
|
REMOVE THE GASKETS AND FOAM FILTER FROM THE VAC MOTOR. SET THESE ASIDE IF NOT DAMAGED,YOU WILL REUSE THESE WITH THE NEW VAC MOTOR.
|
| 14 |
|
REVERSE STEPS 1 THRU 13 TO INSTALL A NEW VAC MOTOR. NOTE: YOU WILL HAVE TO INSTALL THE GASKETS PRIOR TO INSTALLING THE VAC MOTOR.
|